Inspection of Embossed Products

Thanks to the high resolution of the profit it is possible to perform a clear inspection of the embossing on the absorbent paper. Taking a single detail on the paper as a reference, it is possible to pass the correct position of the roll of absorbent paper to the system that controls the plant. The roll will slide under the profit up to the height of the cutting point (trim). In this case, the vision system does not require specific recipes to be managed, although in other types of systems, this cannot be integrated with both recipes and an HMI interface. The software can calculate the distance from the reference to the cutting trim and communicates it to the system management software. The 3D vision sensor toaccepts a maximum roll passage speed of 1.5 m/s during scanning. Profilometer It is connected to a PC, located inside an electrical panel, where the vision software is running. By connecting remotely to a client PC, it is possible to monitor the operation of the vision system and, if necessary, make changes to the various parameters. reference recognition pattern on the paper towel roll. Systems like this are practical and quick to install.